Metalwork cont.
Chassis Fabrication:
'38 Dodge Coupe - Not so much fabrication yet as mock up... All good plans need to start somewhere. Previous owner almost completed the task of fabricating late 70's Dodge Cordoba torsion bar independent front suspension with disk brakes (better handling and good safety updates). I have a Dodge 318 motor and auto transmission to install. Lots of work needed on this one but should be worth it in the long run.
'38 Dodge Coupe - Not so much fabrication yet as mock up... All good plans need to start somewhere. Previous owner almost completed the task of fabricating late 70's Dodge Cordoba torsion bar independent front suspension with disk brakes (better handling and good safety updates). I have a Dodge 318 motor and auto transmission to install. Lots of work needed on this one but should be worth it in the long run.
Sheet Metal Fabrication:
'51 Plymouth Cranbrook - The bottom 6 inches or so of this car had disappeared over the years. Bought rocker panels and fabricated pieces to blend in the bottom of the door pillars.
'51 Plymouth Cranbrook - The bottom 6 inches or so of this car had disappeared over the years. Bought rocker panels and fabricated pieces to blend in the bottom of the door pillars.
Sheet Metal Replacement:
'68 Ford Bronco - Left quarter panel replaced due to collision, front clip replaced, cowl panels replaced and strengthened attaching surface for stainless steel windshield hinge.
'68 Ford Bronco - Left quarter panel replaced due to collision, front clip replaced, cowl panels replaced and strengthened attaching surface for stainless steel windshield hinge.
Sheet Metal Replacement:
'71 Ford Race Courier - Cut off the Mazda front clip a previous race team had installed and went back to a Ford front clip.
'71 Ford Race Courier - Cut off the Mazda front clip a previous race team had installed and went back to a Ford front clip.
Restoration:
'68 Jeep CJ5 - Transfercase and transmission freshened up with all new gaskets and seals.
'68 Jeep CJ5 - Transfercase and transmission freshened up with all new gaskets and seals.
Sheet Metal Fabrication:
'64 Ford Falcon - New aluminum radiator, which needed nice custom sheet metal brackets to hold it in place at 90 MPH across the ice road or through the Nevada deserts. I finally cleaned up the wiring a bit, added a fan controller, and painted my new floors.
'64 Ford Falcon - New aluminum radiator, which needed nice custom sheet metal brackets to hold it in place at 90 MPH across the ice road or through the Nevada deserts. I finally cleaned up the wiring a bit, added a fan controller, and painted my new floors.
Sheet Metal Fabrication:
'52 Dodge Power Wagon - Reattached the A pillar to the floor and fabricated pieces to repair what looks like when someone tried to torch cut the front left body mount.
'52 Dodge Power Wagon - Reattached the A pillar to the floor and fabricated pieces to repair what looks like when someone tried to torch cut the front left body mount.
